The procedures for removing and installing the display digital Scenic 2 are simple and quick, no special tools and without risk to the dashboard. You need a flat and thin object (a screwdriver, a plastic card, a knife round tip) to pry a T15 Torx screwdriver.

Removing the instruments cluster Scenic 2:
First you have to go flat blunt tool between the dashboard and the upper cover and pry down to unclip the clips cache (over the counter), and once you pull completely unclipped.

After that it should unclip and remove the plastic bottom of the main counter. To do this, it must pass a flat blunt tool between the dashboard and the lower cover (under the display). Pry upward to unclip the clips cache. Pull out the cover to unclip the last two clips at each end of the cover. Be careful not to scratch the top of the console cooling with staples under cover.

Then unclip and unplug the two plugs of the display. A lever is used to unlock the gray plug, a simple clip holds red.

Last step: remove the two Torx screws holding the cluster with a Torx T15 screwdriver and then remove the display from its housing.

Your odometer digital Scenic 2 is now disassembled.

Once removed, pack your cluster, do not forget to include the necessary documentation along with your payment (you have the posibility to pay after the repair) and of course your contact details and your full postal address.
Provide an appropriate package for your cluster down to avoid breakage during transit.

Reassembling the display Scenic 2:
Reassemble your dashboard cluster Scenic 2 by taking the inverse operations of disassembly.

Your car is quite able to ride without display, but you can not see you speed, the distance or the fuel gauge or the possible defects. You can use the GPS to check your speed.

The repair warranty of 12 months, even if the removal / installation of the meter on the vehicle is done by youself.
Do not hesitate to contact us via the contact form if you have trouble removing your instrument cluster Scenic 2 down.